Broadband phone adaptors
Broadband phone adaptor helpful information: how to define boardband phone adaptor, how to configure stactic IP, how to verify an adaptor configuration to see if it correct, how to reboost broadband phone adaptors, about Linksys adaptors, how to reset linksys PAP2 devices.

Configure static ip
How to configure static IP for broadband phone device - Instruction on Linksys phone adaptor configuration
To configure static IP for your broadband phone device, please do the following steps:
  • 1. On the phone connected to the Linksys, dial ****. You will hear a voice prompt reading "Linksys Configuration Menu".
  • 2. Press 1 0 1 # on your analog phone to access the Static IP
    configuration Menu.
  • 3. Press 0 # to disable DHCP configuration on your Linksys.
  • 4. Press 1 to save the setting.
  • 5. Press 1 1 1 # to access the IP Address Menu.
  • 6. Enter the device IP Address using the * key in place of the '.'  ( for example: 192*168*1*150 to represent the IP Address 192.168.1.150 ) and press the # key. NOTE: Make sure you are not entering the computer's IP or any IP that you already assigned to a different device on your network ( such as wireless DSL device )
  • 7. Press 1 to save the setting.
  • 8. Press 1 2 1 # to access the Subnet Mask Menu.
  • 9. Enter your Subnet Mask using the * key in place of the . key ( for example: 255*255*255*0 to represent the Subnet Mask 255.255.255.0) and press the # key.
  • 10. Press 1 to save the setting.
  • 11. Press 1 3 1 # to access the Default Gateway Menu.
  • 12. Enter your Default Gateway using the * key in place of the . key ( for example: 192*168*1*1 to represent the Gateway 192.168.1.1) and press the # key.
  • 13. Press 1 to save the setting.
When you finish the 13th step, you have now completed the static IP configuration.